Page 1 of 1
Can you run 5 amps on 1 powercore....???
Posted: Wed Mar 14, 2007 6:59 am
by onecrazy95civic
I have 5 amplifiers and 1 PG 20 Farad Powercore and would like to run all 5 amps on the 1 Powercore, if possible. Can you split 1 output of the PG Powercore to run 2 amplifiers instead of just one or will I have to add a separate cap for the fifth amp. Can anyone tell me if you can or cannot do it???
Thanks
Onecrazy95civic
Posted: Wed Mar 14, 2007 7:51 am
by brenzbmr@sb
well why dont you send one of the outputs to a two way distro block
and then split that to the amp.
then it should be okay
Posted: Wed Mar 14, 2007 8:08 am
by onecrazy95civic
brenzbmr@sb wrote:well why dont you send one of the outputs to a two way distro block
and then split that to the amp.
then it should be okay
that's what I would like to do...but before doing it wanted to confirm if you could, could not or if it was recommended to do it, etc...
Posted: Wed Mar 14, 2007 11:02 am
by bdubs767
as brenz said thats abotu the only way....