Looking at the PG RSD65cs, need a few measurments

anotheruser · Post by **anotheruser** » Tue Mar 03, 2009 2:29 pm

im looking at the rsd 65cs, but i need a couple measurements to make sure theyll fit in the only possible spot i can put them.

ive marked on the image what 3 measurements i need. for Number 2, i need to know the widest point, right before it flattens out.

if some one can get me the measurements, it would be greatly appreciated.

diamondstar · Post by **diamondstar** » Wed Mar 04, 2009 8:38 am

1. 3 1/2 inches 2. 3 7/8 inches 3. 1 5/8 inches ..
These are all as close as I could figure. Doing the measurements with a metal caliper wasnt the easiest thing with the magnet moving it around.

anotheruser · Post by **anotheruser** » Wed Mar 04, 2009 10:32 am

thank you very much. its going to be close, but i think these will work.

diamondstar · Post by **diamondstar** » Wed Mar 04, 2009 11:07 am

what are you using them in?

anotheruser · Post by **anotheruser** » Wed Mar 04, 2009 11:21 am

69 corvette.

anotheruser · Post by **anotheruser** » Wed Mar 04, 2009 1:01 pm

if you dont mind, i need a couple more measurements. i want to make a simple wooden replica. my cars a manual, and after takeing a couple quick measurements, i think im going to be kicking the speaker every time i go to press the clutch. i just want to mock something in there to see if thats going ot be the case or not.