Page 1 of 1
Looking at the PG RSD65cs, need a few measurments
Posted: Tue Mar 03, 2009 2:29 pm
by anotheruser
im looking at the rsd 65cs, but i need a couple measurements to make sure theyll fit in the only possible spot i can put them.
ive marked on the image what 3 measurements i need. for Number 2, i need to know the widest point, right before it flattens out.
if some one can get me the measurements, it would be greatly appreciated.
Posted: Wed Mar 04, 2009 8:38 am
by diamondstar
1. 3 1/2 inches 2. 3 7/8 inches 3. 1 5/8 inches ..
These are all as close as I could figure. Doing the measurements with a metal caliper wasnt the easiest thing with the magnet moving it around.
Posted: Wed Mar 04, 2009 10:32 am
by anotheruser
thank you very much. its going to be close, but i think these will work.
Posted: Wed Mar 04, 2009 11:07 am
by diamondstar
what are you using them in?
Posted: Wed Mar 04, 2009 11:21 am
by anotheruser
69 corvette.
Posted: Wed Mar 04, 2009 1:01 pm
by anotheruser
if you dont mind, i need a couple more measurements. i want to make a simple wooden replica. my cars a manual, and after takeing a couple quick measurements, i think im going to be kicking the speaker every time i go to press the clutch. i just want to mock something in there to see if thats going ot be the case or not.
