Page 1 of 1
Bridging an MS2125
Posted: Mon Mar 23, 2009 6:54 am
by vin78
As the manual states - you must flip the switch to "bridge" and use the left speaker output. However, I was playing around with the switch the other day and and switched it to stereo and there was no difference
Is there another way that I dont know about to bridge the amp?
Posted: Mon Mar 23, 2009 6:57 am
by shaheen
Using the switch allows the amp to be used in a single mono set up , with one INPUT, the bridge is actually on the OUTPUT side with L+ve and Right -Ve .
When using the switch it allows both inputs to be used, but will mono the signal.
Posted: Mon Mar 23, 2009 7:48 am
by vin78
Thanks for the insight. But to run the amp mono, which speaker output do I use? Just the left channel? Or use + for left ch and - from right ch, like most amps?
Posted: Mon Mar 23, 2009 7:52 am
by joerg
If u have the original metal bottom just take a look at it!
Posted: Mon Mar 23, 2009 9:30 am
by shaheen
shaheen wrote: the bridge is actually on the OUTPUT side with L+ve and Right -Ve .
As posted
Posted: Mon Mar 23, 2009 9:38 am
by vin78
Oh I see, thanks
reading > Me sometimes
:D:D