Page 1 of 1
Powder coating???????
Posted: Fri Mar 27, 2009 3:25 pm
by GX3
Any one know of a good place to send my sink off to get re coated ??? If so how much did it run ?
Posted: Fri Mar 27, 2009 4:42 pm
by vin78
I know a place, but its allll the way in socal
Powdercoating is usually pretty cheap and is charged by the batch. My place is pretty cheap and do a nice job (usually). Heck, Im going to have some stuff powdercoatd on Monday.
The only hard part (for us) is to strip the powdercoat, its a PTA to do.
Posted: Fri Mar 27, 2009 4:43 pm
by vin78
btw, your ms275 heat sinks should be ready by midweek
Posted: Fri Mar 27, 2009 5:45 pm
by lashlee
Stop by your local machine shop. They usually powder coat parts on a regular basis and you might be able to let you drop your part in a batch they have going. Or in worst case they can get you in touch with the powder coaters themselves.
Posted: Fri Mar 27, 2009 7:11 pm
by GX3
vin78 wrote:btw, your ms275 heat sinks should be ready by midweek
cool thanks
Posted: Fri Mar 27, 2009 7:16 pm
by GX3
lashlee wrote:Stop by your local machine shop. They usually powder coat parts on a regular basis and you might be able to let you drop your part in a batch they have going. Or in worst case they can get you in touch with the powder coaters themselves.
only problem i might run into is i need to match my blue 2250ta i found a vendor online and they do it all form striping to finish..... i just want a few options and opinions ....I didnt want to go with the first one i found with out talking to a few of you