Page 1 of 1
Elite 9m as a midrange driver.
Posted: Mon Apr 06, 2009 9:52 am
by masonsjeep
Is it possible to use the 9m driver as a midrange in a 2 way system using the TI Elite crossover.
The spec sheet on the 9m says a frequency response of between 40hz - 15khz.
Any ideas.??
Posted: Mon Apr 06, 2009 9:55 am
by stipud
If it sounded good, PG would have done it already. I found the 9M's weren't great above 1kHz. I guess you can try experimenting... but I doubt it will sound good, especially with the factory crossover.
Posted: Mon Apr 06, 2009 10:01 am
by masonsjeep
Bigger plans for the doors may be needed then. Marko also said not above 1 khz.
So unless anyone has tried it back to plan A.
Posted: Mon Apr 06, 2009 10:18 am
by AVICJR
You could try the Morel factory xover, if they are close to the 9" mid and tweet component set they sell together then one of these may work.
http://www.morelhifi.com/products/mob_a ... cross.html
Posted: Mon Apr 06, 2009 11:02 am
by masonsjeep
I have been told to stop being a pu**y and put the full set in. Oh well here goes nothing, now where did i put that jigsaw.
Posted: Mon Apr 06, 2009 3:42 pm
by gkitching
That's the spirit!
Now go hack something up