input cap diameter?

Post by **Jacampb2** » Fri Jun 12, 2009 7:57 pm

Does anyone recall the diameter of the PS input caps on the Ti amps? I am about to order my upgrades for the Ti800's, and forgot to measure. 600.2, 500.4, 1200.1, 1000.2 are all the same IIRC. I know voltage and value, but need diameter only.

TIA!

marko · Post by **marko** » Fri Jun 12, 2009 10:12 pm

edit- seen your other post on other forum, my guess was wrong

Post by **Jacampb2** » Fri Jun 12, 2009 11:27 pm

marko wrote:edit- seen your other post on other forum, my guess was wrong

Actually, I think 18mm might be a bit to large too. Randy and I are discussing it... He was thinking ZX amps (I think)

Thanks though,
Jason

marko · Post by **marko** » Fri Jun 12, 2009 11:47 pm

16mm are a common size and should fit your requirements..

dBincognito · Post by **dBincognito** » Fri Jun 12, 2009 11:49 pm

They are all 18mm, as far as I know....here's a bunch 2 look at

marko · Post by **marko** » Fri Jun 12, 2009 11:52 pm

same as m/ms and zpa then! 2200uf/16v/105c 18mm x 35mm

dBincognito · Post by **dBincognito** » Fri Jun 12, 2009 11:57 pm

marko wrote:same as m/ms and zpa then! 2200uf/16v/105c 18mm x 35mm

Post by **Jacampb2** » Sat Jun 13, 2009 3:37 pm

I measured mine with calipers this morning, Ti600.2, Ti1200.1, and Ti800.1 are all 16mm diameter. The Ti800 ones I had out on the bench, and measured height as well, they are 21mm tall. Anyhow, 18mm should fit, but the factory ones are 16mm.

Later,
Jason

Post by **Jacampb2** » Wed Jun 17, 2009 5:00 pm

Pics, as requested by Randy.

Here are the caps in the Ti1200.1

Here is one of the ones pulled from the Ti800.1

Same as previous, but length measurement

This is one from my TO3 Ti600.2

All of these appear to be the 21mm tall ones as well. Now in defense of numbers quoted previously, my Ti400 I had open today hade 18mm caps in it, as did my ZX450 and ZX250. My Ti1000 had the 16mm ones but some hack had put a mix of old 18mm caps in it as well, evidently in an attempt to trouble shoot...

Later taters,
Jason

dBincognito · Post by **dBincognito** » Wed Jun 17, 2009 5:04 pm

Completely different caps

All of mine are blue and yellow ( gold )

and they are CERTAINLY shorter

the length of those is 1mm shorter than my 450's rail caps

I haven't seen those before in one of mine