ZX475ti Cap Replacement

ShockTherapy · Post by **ShockTherapy** » Sun Nov 20, 2011 11:27 am

Hi guys. I'm getting better with my soldering iron and figured I'd take on this job. I picked up a used 475 and want to replace the caps. Is there a tutorial or something to help me with this? also... I need to know what caps to get. help a brotha out.

tonym · Post by **tonym** » Sun Nov 20, 2011 11:32 am

its in the howto section....

Post by **Eric D** » Sun Nov 20, 2011 1:51 pm

You probably don't need to change the caps unless you just want to play with your iron. I have never seen a Ti amp have caps go bad yet (for the reasons the ZX and other old PG amps do). I have seen a Ti with bad caps due to abuse, but it was some serious abuse.

ShockTherapy · Post by **ShockTherapy** » Sun Nov 20, 2011 5:06 pm

Eric D wrote:You probably don't need to change the caps unless you just want to play with your iron. I have never seen a Ti amp have caps go bad yet (for the reasons the ZX and other old PG amps do). I have seen a Ti with bad caps due to abuse, but it was some serious abuse.

That's cool. I really didn't want to change them but didn't want to risk anything. And the how to section doesnt have anything on changing the ZX caps... other than repairing bad holes while replacing.

ZX475ti Cap Replacement

ZX475ti Cap Replacement

Re: ZX475ti Cap Replacement

Re: ZX475ti Cap Replacement

Re: ZX475ti Cap Replacement