any computer artists that could help?

[ttocs]

I currently have just a plain old set of chrome valve covers with nothing currently written on them. I would like to make a decal that says either ford/mustang 302, and on the bottom of that put "twisted by trick flow"(twisted wedge heads). What I would like to do is to have half of of the word twisted, actually twisted so that the first half "TWI" is normal, the S is in the act of being twisted, and the "TED" be backwards, twisted around its verticle axis. The S and T would be the only letters that would show a difference since E and D will look the same when they are reversed and I think it could be a neat look if done right. I just want some standard block style letters, nothing crazy. IS there someone that can do this on here and help?

[00goobs]

A test:



I was going to try to give it a wedge shape like bigger in the first few letters then smaller near the end, but it seemed a bit harder than I thought. I also didn't read what you wanted until I saved it, so just a test....

[ttocs]

its not a bad design at all and thanks for taking the time. Would it be possible to twist half of the word twisted like I said? I have no idea how to do the letter S like I had talked about. I can see it in my head but no idea how to get it on the screen.

[joerg]

You could also do "Ford 302 Still saving for a grown up engine"

[ttocs]

I thought about something like GT+ or some thing like that.

just an FYI, the are called twisted WEDGE heads.