Sdt rddp schematics

[freshkryp69]

Anyone have schematics to the Sdt volt gauge, the "Dakota Digital" version.. Im trying to figure how to make the diag leds work with a non PG amp.. When looking into the female part on the gauge, I know pins 5 is (+) and pin 7 is the (-).. Im sure all the diag leds on the sdt gauge are triggered with a (+) signal..

thx

[dvnt88]

^^^^ Here's what I have that was pulled from the manuals FTP on the phorum ...hope this at least helps out.

http://download.phoenixphorum.com/TechS ... Pinout.pdf

http://download.phoenixphorum.com/Manua ... ctions.pdf

[freshkryp69]

Thanks bro, I have those to.. I just wanted to make sure 100% which wires were which as im going to use this sdt gauge with a different brand amp, which also has a protect and clipping leds..so If I can wire it up right then ill know whats up with the amp just like the PG amps..

[ttocs]

not sure how I missed this but I can help. The R-link is basically just a piece that reads the led status of the power/over leds and repeats them but if I remember correctly from what I saw it was triggered by a negative signal. pm me and I think I can help.

[Alfaholic]

Hi i saw this and i got a question, the RJ45 telephone cabel from the R-link to the display is that just a regular RJ same pin layout or are some changed?