ZX-350 fan issue...

flogger11 · Post by **flogger11** » Fri Jul 04, 2008 12:15 pm

My fan on my ZX-350 doesnt turn on unless I tap on the top of the chassis, I assume the bearing in the fan is bad? Where does one go to get a replacement fan? Thanks guys~ Mike

KHPower · Post by **KHPower** » Sat Jul 05, 2008 4:22 am

I was recently in my ZX500 and I should of did some fan measuring

most of the fans in amps are really nothing special , just get the H x W and begin looking online or at the local computer place for a good quality fan. I am thinking of changing 2 in my bahn to some sleek ball bearing fans. You could also get some that light up different colors.

I think a basic computer's power supply fan is the same size but not sure

fordtough1 · Post by **fordtough1** » Sat Jul 05, 2008 4:56 am

I know you want to be careful about the amperage, or milliamps in this case that they draw or you can hurt the fan output part of the amp. At least that's what I've been told.

flogger11 · Post by **flogger11** » Sat Jul 05, 2008 5:37 am

Thanks so much guys, I'm off on a fan hunt!

KHPower · Post by **KHPower** » Sat Jul 05, 2008 6:11 am

fordtough1 wrote:I know you want to be careful about the amperage, or milliamps in this case that they draw or you can hurt the fan output part of the amp. At least that's what I've been told.

Good point! i would just match all the specs listed on the PG fan itself and find a replacement @ a computer store or do your research and purchase a good one online.

Not that the PG fan is horribly loud but alot of amps do have a little fan noise and if you wanted that reduced you could purchase a real nice computer fan. I know that the PG amps fan is smaller than a computer case fan but there are so many varieties. I probablly have 10 fans laying around , some from amps and some from the puters

flogger11 · Post by **flogger11** » Sun Jul 06, 2008 2:50 pm

Well, I finally sourced an exact match fan, $48 to my door, lame. Oh well, its on its way...

Post by **AVICJR** » Sun Jul 06, 2008 2:51 pm

flogger11 wrote:Well, I finally sourced an exact match fan, $48 to my door, lame. Oh well, its on its way...

Have you tried PG for this part? If they have one I bet it will cost you much cheaper than that.

flogger11 · Post by **flogger11** » Sun Jul 06, 2008 2:53 pm

AVICJR wrote:
flogger11 wrote:Well, I finally sourced an exact match fan, $48 to my door, lame. Oh well, its on its way...
Have you tried PG for this part? If they have one I bet it will cost you much cheaper than that.

SHIT! I bet you are right! Too late for me as I have already charged it to my card... What a dumbass, eh? LOL!

ZX-350 fan issue...

ZX-350 fan issue...

Found one, not cheap!

Re: Found one, not cheap!

Re: Found one, not cheap!