Custom RCA cables?

SolacE · Post by **SolacE** » Sat Mar 14, 2009 6:58 am

Can anyone on here make me some short rca cables?? I need 6 total pair in specific lengths for inside a custom amp. Also need male on one end and female on the other.

dBincognito · Post by **dBincognito** » Sat Mar 14, 2009 7:01 am

How much do you want to spend

dBincognito · Post by **dBincognito** » Sat Mar 14, 2009 7:08 am

It's not very hard

The one's you can make will blow away the one's you can buy

lashlee · Post by **lashlee** » Sat Mar 14, 2009 7:33 am

I don't care to if you can get me all the stuff. I can get a hold of some stuff but I'd prefer that you get what you want. I've had to swap ends on my Zeropoint Pro Musical Reference RCA's as well as made up some old ones with STS cables.

wash with gasoline · Post by **wash with gasoline** » Sat Mar 14, 2009 11:13 am

id offer to do it but i cant find my soldering gun

its not to hard to do just dont forget to slide the cover down the wire before you solder it all together. sux when you have to do it twice

wow those pics are crappy

il take some fresh ones next time i do it, not with the cell phone this time...

Post by **ttocs** » Sat Mar 14, 2009 1:02 pm

there was one shop that I worked at that made all their own rca's. They just kept some small gauge high current cable that we would twist together with our drill and then solder when we knew the exact length.[/u]

SolacE · Post by **SolacE** » Sat Mar 14, 2009 3:56 pm

I have to measure to see how long they need to be and the amp is not at my house right now. I would like them to be of the highest quality within reason. I would like to keep the total cost under $180. Seeing as how they will all be between 12" and 30" that shouldnt be a problem. Its not that I cannot do it, but I am buying a house and that means moving. So I will have everything spread from here to there for a while. I wont have my workshop set back up for a few months probably. Also dont have a work bench in the new garage so I have to build one. UGH!!!!!

So it would just be easier to pay someone this time around.

dBincognito · Post by **dBincognito** » Sat Mar 14, 2009 4:00 pm

I will check through Digi-Key tonight and get back at you with all of the part numbers so you know how much it will cost.

The parts will be top notch including super bad Teflon/Kevlar shielding

SolacE · Post by **SolacE** » Sat Mar 14, 2009 5:46 pm

that would be great. again no hurry it will be tuesday before i can get back to the shop and measure to see how long the cables will each need to be.

dBincognito · Post by **dBincognito** » Sat Mar 14, 2009 6:46 pm

Just let me know how long they need to be