ms amps

JK · Post by JK » Fri May 07, 2010 3:25 am

why does the ms250 have green wires like ms2250 and not red wires like the ms275,mps2125,mps2500 ect.. what is the difference between the 2?

Post by **mhyde71** » Fri May 07, 2010 4:19 am

do you have pic to show what your referring to exactly...? you mean on the transformer or the speaker coil thingy ...?
I am not sure i can say that i have ever seen a green wired anything in a 250

Post by **stipud** » Fri May 07, 2010 7:04 am

Back in the day, PG would use whatever they had lying around. Finding two matching M's or MS is like finding two of the same snowflake

marko · Post by **marko** » Fri May 07, 2010 7:38 am

stipud wrote:Back in the day, PG would use whatever they had lying around. Finding two matching M's or MS is like finding two of the same snowflake

true on the ms2250 and zpa's but i have never seen green wire on an ms250/275 or 2125..

Post by **mhyde71** » Fri May 07, 2010 9:25 am

neither have I ^^^^^

Post by **stipud** » Fri May 07, 2010 10:08 am

Hell i've seen green wire in M series amps too. If they ran out of red they would use green in a pinch. PG was basically built out of a garage for the first while. The earliest revisions of these amps had the most variety, but even the late models have quite a few differences, even within the same revision.

JK · Post by JK » Fri May 07, 2010 10:32 am

how do i post picts? that board and a 2250 would look good in the same sink. i should hold on to that one. ill post it!

JK · Post by JK » Fri May 07, 2010 10:33 am

the coil! i never looked under the tape