RSD 6.5" dimensions

Audiophiliac · Post by **Audiophiliac** » Sun May 31, 2009 6:46 am

Can someone with a RSD 6.5" measure it to find out 2 things:

1. Overall diameter

2. Mounting diameter (distance between the mounting holes....mine uses 4 holes 90 degrees from each other)

I know 2 speaker that I have used fit perfectly with no mods to my doors. Exile XT65 and ID CX62. I am thinking of trying the RSDs if they will fit good.

Thanks!

waynehead · Post by **waynehead** » Sun May 31, 2009 8:08 am

I am all about trying them too. I just ordered a pair yesterday and dont even have anything to put them in. I dont understand replacing the the cx62's tho.

Audiophiliac · Post by **Audiophiliac** » Sun May 31, 2009 9:41 am

I am not replacing anything. I have none speakers at the moment. I had CX62s in my old GTI. Then I upgraded to the XT65s. And yes...it was an upgrade. They sounded better.

I want to just order another set of those and call it good. But I thought I would try some PG stuff.

I had Xenons before and liked them...but they lacked anything below 150Hz or so.

Audiophiliac · Post by **Audiophiliac** » Wed Jun 03, 2009 9:16 pm

bump. someone measure

Post by **Bfowler** » Thu Jun 04, 2009 9:18 am

i can hook that up for you later today mang.

Audiophiliac · Post by **Audiophiliac** » Thu Jun 04, 2009 4:31 pm

Its later!

Post by **smgreen20** » Fri Jun 05, 2009 11:17 am

5 11/16" over all outside dia. 5 7/16" from center of mount hole to center of mount hole Diagonally.
4 mount holes at 90 degrees.

Audiophiliac · Post by **Audiophiliac** » Fri Jun 05, 2009 4:22 pm

Bummer....too small. Back to Xtecs or ID CXS v2. Seems like they fixed the problems with dust getting in the gap...that is why I sold my old CXS62.

Post by **smgreen20** » Fri Jun 05, 2009 6:13 pm

Audiophiliac wrote:Bummer....too small. Back to Xtecs or ID CXS v2. Seems like they fixed the problems with dust getting in the gap...that is why I sold my old CXS62.

I'm sorry dog, my bad. It wasn't 5 7/16" it's 5 15/16". When I wrote it down, I subtracted 1/8" per side instead of added for the mount screw holes.