Can I use a fuse distribution box in place of an Inline ANL

Capital_M · Post by **Capital_M** » Wed Mar 21, 2007 11:21 am

The only Knukoncepts distribution block that can take 1/0 gauge input/output is also a fuse block. But its not water proof.

Or should I use both an ANL and a Fuse Distribution block

Post by **AVICJR** » Wed Mar 21, 2007 11:43 am

Use both, the inline fuse goes as close to your battery as possible, and the dist. block should be close to where you mount your amps.

1moreamp · Post by **1moreamp** » Wed Mar 21, 2007 12:35 pm

I have a TIBBKF-3? that goes 1/0 in and 2 1/0 out but that pretty much what your asking about right?

And no they are not water proof at all, but its real pretty in that Ti finish with those pretty indicator lights inside. Its almost worth mounting in a plexi housing under the hood < I got a guy that does custom plexi affordable>

Capital_M · Post by **Capital_M** » Wed Mar 21, 2007 12:52 pm

1moreamp wrote:I have a TIBBKF-3? that goes 1/0 in and 2 1/0 out but that pretty much what your asking about right?

And no they are not water proof at all, but its real pretty in that Ti finish with those pretty indicator lights inside. Its almost worth mounting in a plexi housing under the hood < I got a guy that does custom plexi affordable>

fuckin niiiiiiice

1moreamp · Post by **1moreamp** » Wed Mar 21, 2007 12:57 pm

Yeah I think so too, they are getting real hard to find also, from what I am told> I have already had three offers for it.

Capital_M · Post by **Capital_M** » Wed Mar 21, 2007 12:59 pm

If I was doing a real nice show off install I'd probobly look into one, but for now knukoncepts will do just fine