Line driver before or after bass cube??

james--hughes · Post by **james--hughes** » Wed Jul 22, 2009 8:27 pm

Should I install the line driver before or after the bass cube? Thanks for all the help too guys. It has been super helpful.

Post by **ttocs** » Wed Jul 22, 2009 9:13 pm

I thought the cube already boosted the voltage?

james--hughes · Post by **james--hughes** » Wed Jul 22, 2009 9:30 pm

oh maybe it does? I thought you could use both, but maybe not??

Post by **AVICJR** » Wed Jul 22, 2009 9:40 pm

Line driver before Bass Cube. Install it as close to HU as possible.

fordtough1 · Post by **fordtough1** » Thu Jul 23, 2009 4:25 am

^^^^what he said^^^^

fordtough1 · Post by **fordtough1** » Thu Jul 23, 2009 4:26 am

^^^^what he said^^^^

Stryker · Post by **Stryker** » Thu Jul 23, 2009 4:29 am

Bass CUBE does not have a line driver. Install close to HU

Post by **smgreen20** » Thu Jul 23, 2009 5:59 am

The BassCube uses unitygain, meaning what's put in is what it puts out. Example, 1v in/1v out, 12v in/12v out.

So yes, put the BassCube after the line driver. Besides, the BassCube would normally be installed in the trunk/rear of the vehicle which is why a line driver would be needed anyway.

james--hughes · Post by **james--hughes** » Thu Jul 23, 2009 3:34 pm

Thanks guys. I have it hooked up like that right now. I am trying to find a TLD 66 to replace the current driver so I can boost the signal to both my other lines for my front and rear stage too.

Post by **ttocs** » Thu Jul 23, 2009 4:07 pm

I was wondering why you would want to boost just the bass signal unless you were going for a strictly spl use.

Post by **smgreen20** » Thu Jul 23, 2009 5:52 pm

He does state he's going to get a TLD66 to replace the one he has, so at that point it will be all but, I do see your point- the one he has now was bought and used.