help pg ti 1000.2

lycheenutz · Post by **lycheenutz** » Tue Aug 04, 2009 8:54 pm

i hooked up the amp to 1 JL 12w6 in a band pass box and the sound is really distorted. i tried the sub on a my buddy's amp and its sounds fine. new to this so if any can help that would be great.

wash with gasoline · Post by **wash with gasoline** » Tue Aug 04, 2009 9:07 pm

Did you put your buddys amp into your setup or put the box into his car?
What head unit, power wire ect are you running?
What do you have the crossover, gain and bass boost set at on your amp?

lycheenutz · Post by **lycheenutz** » Tue Aug 04, 2009 9:13 pm

i put the box in my buddys car. i running and alpine head unit with really thick gauge power wires. im pretty sure its not my setup because i took my beats out last year and just trying to install new amp and sub this time.

lycheenutz · Post by **lycheenutz** » Tue Aug 04, 2009 9:15 pm

i tried setting the bass, and sens low and high but still sounding funny. im pretty sure something is wrong with the amp, just curious if anyone would know what im talking about

lycheenutz · Post by **lycheenutz** » Tue Aug 04, 2009 9:23 pm

i'm running an Alpine CDE-9874 head unit, powerflex4 monster cable power wires with street wire RCA's

wash with gasoline · Post by **wash with gasoline** » Tue Aug 04, 2009 9:24 pm

If its been awhile since you have had a system in i would double check all the power and ground connections to make sure nothing got loose or corroded.
Im not a amp tech in the slightest... But i would try hooking up another amp in its place and if it sound good i would blame the amp, if not start hunting the car for grimlins

lycheenutz · Post by **lycheenutz** » Tue Aug 04, 2009 9:24 pm

wash with gasoline
does this info help??

lycheenutz · Post by **lycheenutz** » Tue Aug 04, 2009 9:28 pm

wash with gasoline
the amp powers on..its just not producing the proper sounds. i checked all the wires and tested all 3 of the rca's i got and still comes down to the ti 1000.2 that i think is not working properly. what should i have the crossover set at if im just trying to push one sub..possibly bridged

wash with gasoline · Post by **wash with gasoline** » Tue Aug 04, 2009 9:31 pm

if it is the amp there are some people on here that are good at fixing them if you are patient. this place isnt the fastest moving forum out there, but there is lots of help if you stick around

...and if you dont want to fix it there are a few that like buying busted amps for projects as well

wash with gasoline · Post by **wash with gasoline** » Tue Aug 04, 2009 9:43 pm

set the config to Lp, does not matter which of the 2 Lp if you are not piggy backing another amp off of it. I would set the crossover around 80 and tune it till it sounds rite.
My internet is SLOW rite now so i did not google your deck to see what voltage it puts out, but i would start with it up around a 3rd to start out.
Ti amps like to run with a little bass boost so i would turn it up around a 3rd and tune from there.

If the amp has been sitting awhile you might try turning all the knobs and crossover a few times incase there is dust in the switches...

wash with gasoline · Post by **wash with gasoline** » Tue Aug 04, 2009 10:07 pm

just noticed you said 3 sets of rca, if your deck has a built in crossover you probly want to bypass the one on the amp and use the one in the deck... Im assuming since you said you had a system in before that you are familiar with the crossover functions of the deck.

Ok gave up and waited for the internet, crutchfield says it has 2v preamp outs which is low, probly going to have to run the gain prity high. there is a good thread in the how to area on setting gains with a meter, but we need to see if it works before that

Crutchfield also said that it has 2 sets of pre outs one that can be run as a sub out. I would make sure you have all the bass boost and eq on the deck set flat and the set of rca going to the amp set up on the sub out set around 80hz and go from there.

I dont know if i have anything else i can suggest to help. welcome to the phorum by the way...

Post by **stipud** » Wed Aug 05, 2009 7:14 am

Next thing to try is your amp in your friends car. If it makes the same noise there, odds are it's pooched.

No need to post three threads for the same issue...