so help set up my amp....

Pug}{maN · Post by **Pug}{maN** » Mon Mar 08, 2010 6:58 am

MB Quart DSC2150 Discus Series 2-Channel AMP, need help with seting it up, i have no clue on how to do it. i numbered all the settings 1 2 3 4 5 to help. it will be running 1 pg rsdc 12 2 ohm, the amp will be at 4ohm x 1 at 600w rms...

Post by **joerg** » Mon Mar 08, 2010 7:26 am

1: Set it to 0 to start with
2: Set it to LP/BP Mono
3: Turn it up half way between 30Hz and 150Hz. Should give you arround 75HZ
4: No need to adjust this one for sub duties.
5: Set it to the lowest possible point to start with. Adjust your radios volume as high as you front speakers can take it (Even stay a little lower so you won´t damage them) and start to match the sub output by turning this poti so it matches with your frontstage.

I hope that helps.

Pug}{maN · Post by **Pug}{maN** » Mon Mar 08, 2010 7:40 am

sounds good to me..thanks...

Post by **stipud** » Mon Mar 08, 2010 8:26 am

One small correction... for #4, set that as low as possible. From the looks of it that knob can be used as a subsonic filter (i.e. it goes as low as 10Hz). The LP/BP setting probably uses both the low and highpass settings.

Pug}{maN · Post by **Pug}{maN** » Mon Mar 08, 2010 8:48 am

eazy-e · Post by **eazy-e** » Sun Mar 14, 2010 2:50 pm

im glad i got rid of my maxxsonics amps, they are very over rated atleast my bxi1208d, it was supposed to be 1200watts at 1 ohm, and it seemed like alot less than the rear channel of my zx450 bridged at 4ohms!!!