line driver question

12voltjunky · Post by **12voltjunky** » Sun Mar 21, 2010 11:25 am

would a single 2 channel line driver
work to drive a pair of PG ti amps
if using the outputs from one amp to
take the signal to the input of the other amp?

Post by **AVICJR** » Sun Mar 21, 2010 11:28 am

Yes, it will work for both. What goes in is same that comes out.

12voltjunky · Post by **12voltjunky** » Sun Mar 21, 2010 11:41 am

thanks for the quick reply.

my head unit has two sets of outputs.
if I ran a 4 channel LD, would the only
advantage be fader/bal control?

Post by **AVICJR** » Sun Mar 21, 2010 11:48 am

You are correct. You will be able to keep the fade function control through your HU.

Post by **AVICJR** » Sun Mar 21, 2010 11:57 am

After thinking about it some...... you can also use the xover in the first amp to send a HP/LP signal to the next amp.

12voltjunky · Post by **12voltjunky** » Sun Mar 21, 2010 12:05 pm

AVICJR wrote:After thinking about it some...... you can also use the xover in the first amp to send a HP/LP signal to the next amp.

I plan to use that feature as I am
rewiring a few things. Thanks for your input!