MPS-2500 Cap upgrade quotes.

Shinju · Post by **Shinju** » Sun Mar 21, 2010 6:44 pm

Athough the amplifier works I would like to get this one recapped.

Looking for a tech local US that has time to do this and could give me a quote.

thanks.

Post by **Eric D** » Sun Mar 21, 2010 7:22 pm

I would do it for $75 plus shipping back to you. (This would be the 12 input supply caps)

Shinju · Post by **Shinju** » Sun Mar 21, 2010 7:36 pm

What about the 4 larger ones?

75+ shipping sounds reasonable. What is your zip? I might just buy a shipping lable for the trip back.

Thanks Eric

-j

Post by **Eric D** » Mon Mar 22, 2010 7:11 am

ZIP 49457

Do you have some detailed photos you can post of it? The 4 large rail caps pretty much never fail. Their only failure I have ever seen is if they get too hot the heat shrink starts pulling down on them and they look bad. But even then they are usually fully functional.

Shinju · Post by **Shinju** » Mon Mar 22, 2010 9:15 am

Here you go.

I can also email you this photo too, its pretty high res.

Post by **Eric D** » Mon Mar 22, 2010 10:14 am

That looks like it is in very good condition. I highly doubt there are any issues with the big blue capacitors.

Everything else about the amp works just fine, right?

Shinju · Post by **Shinju** » Mon Mar 22, 2010 12:02 pm

Eric D wrote:That looks like it is in very good condition. I highly doubt there are any issues with the big blue capacitors.

Everything else about the amp works just fine, right?

Amp works flawlessly as it sits right now, Just a cosmetic baskit case

PM me your address and I'll get this shipped to you this week if you have the time.

thanks

-j