buying new caps

Need help with your car stereo system? Have a technical question? Post here.
Post Reply
User avatar
dontlookatme
Posts: 676
Joined: Thu Mar 18, 2010 2:34 pm
Location: SO-CAL

buying new caps

Post by dontlookatme »

my system has been sounding a little tired over the years. the car was in storage for almost 2 years because of a dui. and the rest of the time took care of my system not tinkering with it. or forcing it and playing good tones. so i think i wanna be better safe than sorry and replace the caps on all my ti amps.

this is what i have

500.4 x 4
600.2 x 3
1000.2 x 2
1200.1 x 1

what caps do i need to buy
3x ti600.2, 1x ti1000.2 (hidding in the closet),1x 6.5 ti elite comp (front), 1x 5.25 ti elite comp (back), 2x XO crossovers, 2x tantrumX dual 4 ohm, zero point full power+ ground wiring
6x pc-ccc zero point rca
storage for the rest of my stuff
User avatar
tonym
Posts: 1653
Joined: Sat Jun 13, 2009 6:17 am

Post by tonym »

User avatar
dontlookatme
Posts: 676
Joined: Thu Mar 18, 2010 2:34 pm
Location: SO-CAL

Post by dontlookatme »

do they all use the same caps? where do i buy them?
3x ti600.2, 1x ti1000.2 (hidding in the closet),1x 6.5 ti elite comp (front), 1x 5.25 ti elite comp (back), 2x XO crossovers, 2x tantrumX dual 4 ohm, zero point full power+ ground wiring
6x pc-ccc zero point rca
storage for the rest of my stuff
User avatar
tonym
Posts: 1653
Joined: Sat Jun 13, 2009 6:17 am

Post by tonym »

digikey.com
User avatar
Thunderdome
Posts: 806
Joined: Mon Feb 09, 2009 4:19 pm
Location: Ont.

Post by Thunderdome »

dontlookatme wrote:do they all use the same caps? where do i buy them?
just open them up and take a look then call up digi key and order em they,re pretty helpfull
-
-
-
Remember: The chart serves only as a starting point. Ultimately you must use your ears as a guide.
User avatar
12voltjunky
Posts: 565
Joined: Tue Dec 15, 2009 5:10 pm
Location: Atlanta, GA

Post by 12voltjunky »

Digi Key is a great company.
1- Zx 400 Ti
1- Ti 600.2
1- Ti 500.4 (resurrected by valeks1)
2- Ti 500.4
2- Ti 1000.2
2-Ti RMD, Lpl, PG 1/0 Ga
Ti 6.5 comps, Ti 5x7 coaxials
User avatar
Eric D
Short Bus Driver
Posts: 4259
Joined: Sat Dec 30, 2006 8:50 am

Post by Eric D »

None of those amps should need new caps. They are newer than when PG had all these cap problems.
Got "schooled" by member shawn k on May 10th, 2011...
No longer really "in tune" with the audio industry, and probably have not been for some time.
Hands down the forum's most ignorant member...
Don't even know what Ohm's law is...
User avatar
dontlookatme
Posts: 676
Joined: Thu Mar 18, 2010 2:34 pm
Location: SO-CAL

Post by dontlookatme »

well if they are circa 2002 then doesnt that mean its close to the 10 year age of a cap n e ways?
3x ti600.2, 1x ti1000.2 (hidding in the closet),1x 6.5 ti elite comp (front), 1x 5.25 ti elite comp (back), 2x XO crossovers, 2x tantrumX dual 4 ohm, zero point full power+ ground wiring
6x pc-ccc zero point rca
storage for the rest of my stuff
User avatar
Eric D
Short Bus Driver
Posts: 4259
Joined: Sat Dec 30, 2006 8:50 am

Post by Eric D »

There are Rockford amps which are 20 years old and they don't have cap issues. PG used a manufacturer who apparently had a bad run of these, as they are the only amps I have seen with this level of cap problems. The Ti amps use a newer version of them, so they should not be a problem.

If you wish to replace them for peace of mind, then that is fine. However, replacing caps often causes other problems, so if an amp does not need them, I try to stress that people don't change them.
Got "schooled" by member shawn k on May 10th, 2011...
No longer really "in tune" with the audio industry, and probably have not been for some time.
Hands down the forum's most ignorant member...
Don't even know what Ohm's law is...
Post Reply