will a RMD work on zx amp or zxti or ti amp?

[kg1961]

will it work on say a zx950 or a octane le? all i read is the unit that is seperate and cost like 200 if i get one i would not want to spend that...
let me know how had used it if it works

also there was a member here that had a zx950 install in the trunk with one of 2 rmd looking item above the amp who are you?

[ttocs]

you can use the rmd on any amp if you cut the one end off.

The original zx amps did not have the plugs but the Ti amps did.

[smgreen20]

The ZX amps do have a plug for it. My 450 does. If it's what I'm thinking. RDM and LPL plugs.

[rscecil007]

Pretty sure the RMD works on the Ti distro's that use the KF fuses as well.

[joerg]

Pretty sure the RMD works on the Ti distro's that use the KF fuses as well.

It works on any distro with a minor change that takes a soldering iron, about 2 inches of wire and 10minutes of time

[kg1961]

so what would i have to do to make it work on say a zx950 the sub side?
I can soilder so not problem there wiring or drawing please

[joerg]

so what would i have to do to make it work on say a zx950 the sub side?
I can soilder so not problem there wiring or drawing please

I´ll get u all the info and pic´s tonight mike!

[kg1961]

thanks man can't be that hard is it? just change a differnt end Im guessing

[stipud]

The small Ti amps only have an RDDP port unfortunately

So you need to convert this:
http://download.phoenixphorum.com/TechS ... Pinout.gif

To this:
http://download.phoenixphorum.com/TechS ... Pinout.pdf

[kg1961]

so just 5 and 7 on the rddp than and make it the 4 pin rmd on the phone jack?

[smgreen20]

RDDP, My bad.

[eulogious]

The small Ti amps only have an RDDP port unfortunately

So you need to convert this:
http://download.phoenixphorum.com/TechS ... Pinout.gif

To this:
http://download.phoenixphorum.com/TechS ... Pinout.pdf

I will be doing this for a friend coming up here soon, so looking at those diagrams, on the RDDP you only need pins 5 and 7 wired to pins 1 and 3 on the RMD, and the other 2 from the RMD you just ground? Is that how it works?

[rscecil007]

Pretty sure the RMD works on the Ti distro's that use the KF fuses as well.

It works on any distro with a minor change that takes a soldering iron, about 2 inches of wire and 10minutes of time

Very true, but it just plugs into the Ti KF block with no modification needed right? I swear I read that on here....

[stipud]

RMD pins 1&3 to RDDP pin 5
RMD pins 2&4 to RDDP pin 7

[eulogious]

RMD pins 1&3 to RDDP pin 5
RMD pins 2&4 to RDDP pin 7

Damn, I was close! Thanks for the info! I might have just come across one of those fuse holders, so my problems might be solved, but it great to have a backup plan

[joerg]

Looks like no more pics needed here!?!