relay ?

twisted · Post by **twisted** » Sun May 23, 2010 6:51 am

ok guys......since its been 15yrs since i've had to wire a realy can somebody give me a pin diagram to wire a 5 pin relay to run power to my fans with a remote turn on?

the relays i have dont have the diagrams on the back.

thanks in advance

Pedi · Post by **Pedi** » Sun May 23, 2010 7:34 am

30: B+ Power
85: Earth/ground
86: Remote power in
87: Power out...

Post by **ttocs** » Sun May 23, 2010 8:01 am

be sure to insulate terminal 87a, or wire it to a switched power source or that terminal will be live when the relay is not energized.

twisted · Post by **twisted** » Sun May 23, 2010 10:35 am

thanks gents

brenzbmr@sb · Post by **brenzbmr@sb** » Sun May 23, 2010 11:48 am

or put the output on 30 and the 12volts on 87a then u dont have to worry about insulating anything

i usually use 30 as the output.

Post by **ttocs** » Sun May 23, 2010 1:57 pm

me too, threw me off for a sec....

Pedi · Post by **Pedi** » Sun May 23, 2010 2:09 pm

And I don't...

But I have mostly worked with European cars for a living...

Buuut.. I worked with Chrysler for 3 years (from 1995 to 1998), and if I recall right, Chrysler (read: new cars) used 30 as B+ and etc. aswell....