Got me a pair of dual 4ohm voice coil subs that Im gonna bridge my X200.4 to.
Would 2 or 8 ohm mono be best on the 200.4?
You would think that that 8ohm mono would be better. I know the Xenon is rated 1-8 ohm stereo but I noted that on the ratings for the mono amps they are only rated 1-4ohm.
Also second question.
My signal path is going to be:
HU to my EQ30, EQ30 to my X200.2 then the output of my X200.2 to my X200.4.
I have a BassCube to put in there somewhere. At first I thought about putting it between my 200.2 and 200.4 then I got to thinking ....... would there be some benefit to putting it right after or just before my EQ30 so it effects the signal going to both amps??
Hey Errin
-
VW337
- Meatgician
- Posts: 2781
- Joined: Wed Dec 06, 2006 9:53 am
- Location: Under a foil-hat in the midwest
The Xenon amps when bridged are 2-8 ohm so either way you wire it is good.
Wire your BQ where you want but I would wire it prior to the EQ so all items see the adjustment equally instead of creating a peak from the subs that would make them directional if the mids didn't receive the emphasized harmonics to blend it better.
Wire your BQ where you want but I would wire it prior to the EQ so all items see the adjustment equally instead of creating a peak from the subs that would make them directional if the mids didn't receive the emphasized harmonics to blend it better.
I think we've established that "Ka Ka" and "Tukki Tukki" don't work.