Project White MQ475

Post by **joerg** » Mon Oct 25, 2010 9:55 am

Since a deal from me went down the drain i was left with a smashed sink from a MS2250. I brought it to a guy local to me and had it blasted. Today i bought some liquid metal and closed all the holes and repaired the spots that where damaged. I will get coated white in the future. On the other side i bought a few MS275´s not too long ago which 2 are REV.F and nearly match each other.

I recapped both boards and they are waiting to go into their new sink. I´m going for a white MQ475 ths time.

First pictures:

marko · Post by **marko** » Mon Oct 25, 2010 10:36 am

nice! are you going to re-drill and tap the threads for the clamps? i always wondered how pg (and others for that matter) did this process for such a shallow hole without going through the sink!

Post by **joerg** » Mon Oct 25, 2010 10:51 am

As i want this amp to match the white MS1000 i´m going with clamp down bars here as well. And it´s an easy thing to redrill and retap the holes with proper tools. I bought a tool you can fix onto the drillbit so u can´t go thru the sink.

Pedi · Post by **Pedi** » Tue Oct 26, 2010 8:41 am

Where do you get all those clamp bars from?

Post by **ttocs** » Tue Oct 26, 2010 8:57 am

wouldn't be hard to make then would it?

Post by **joerg** » Tue Oct 26, 2010 9:38 am

Pedi wrote:Where do you get all those clamp bars from?

How many and what kind do you need pedi? Those bars a made out of AL. It takes about 30 mins to make a set for a whole MS1000. Those would be bare ones then.