zero point fuse blocks

Post by **ttocs** » Wed Nov 03, 2010 2:49 am

hope someone can help me find a model number? I need to find the model number of one of the zero piont fuse blocks with 1-1/0 input and 4 outputs with all the cool little lights and such?

Post by **joerg** » Wed Nov 03, 2010 3:08 am

There was no such thing! The only one u could get is the one with three 1/0 inputs and four 8/4 outputs. Named ZBB34 or ZBB34TI

Post by **ttocs** » Wed Nov 03, 2010 3:31 am

ah well that would do, doesn't matter if there is an extra input er two. Anyone have an extra they are not using? Cover condition would not be a big deal?

Post by **joerg** » Wed Nov 03, 2010 3:55 am

I have the gut´s but no housing

Post by **ttocs** » Wed Nov 03, 2010 5:31 am

ahhhhh joerg you might be my hero one more time!!!! Unfortunatly to mount mine in my console required a little modification, mainly I had to cut the mounting tabs on the end of mine to fit in the small area

. While I was not happy about it I use 3m double stick tape and the way the wires are mounted to hold it in place. So rather then cut up another case I was lookin to get one and then I was goin to swich out the case for the one I had cut up. I was also going to see if I could modify this one, to make 2 of the 8/4 awg outputs to be a single 1/0 output with two fuses and keep the other two the way they are. Is that 0 awg lug that I bought from you out of one of these? If so then please post some pics so I can confirm the mounting is the same and how much do you want for it?

Post by **joerg** » Wed Nov 03, 2010 6:06 am

I have one left u can have for 25USD plus shipping. I could also ship it with your stuff from mandrops which should show up this or next week.

Post by **ttocs** » Wed Nov 03, 2010 6:10 am

SOLD SOLD SOLD!!!! FREAKIN PERFECT MANG! Like I said I will be able to remove two of the 8 awg outs to put that 1/0 you sent me a month or two ago. This way I will be able to run my 1/0 to the dist block, then 1/0 to the roadster, 8 awg to the DD5 and 8 the mq430 I am going to use for rear fill. I will need to drill some new holes in the side of my current case, but they will not be seen from directly above it where it can only be seen from so whats the difference.

Post by **joerg** » Wed Nov 03, 2010 6:13 am

It´s yours Scott!