Opinion on PG Wiring kits

dgoodhue · Post by **dgoodhue** » Fri Jun 22, 2007 5:14 am

http://cgi.ebay.com/New-PHOENIX-GOLD-AK ... dZViewItem

Does anyone have any opinions of the PG wiring kits on ebay.

I have my battery relocated to the back of the bed in my truck, I currently wire have 2 gauge wire (PG ultraflow thin strand) to my starter, but I would like to upgrade it to 0 guage. I need 16-17 feet of power wire and 2 1/2 feet of ground, so i do acutally need all that wire. The last time I bought the stuff it was $5/ft and it cost me $110 for just the wire, so this will cost me about the same for 0 guage wire.

Post by **VW337** » Fri Jun 22, 2007 7:10 am

It's a good kit no question.

Post by **AVICJR** » Fri Jun 22, 2007 7:45 am

Look on the PG website, it comes with the high end + battery terminal. Those are beautiful. It will make you want to buy the neg. to match.

Post by **Bfowler** » Fri Jun 22, 2007 1:09 pm

The akit one is the onlt nice kit in the current pg line. I go through LOTS of their kits.

For 8 and 4 gauge i would direct you to knuknoceptz, but pg's 1/0 kit is quite good. The battery terminal makes it well worth your while.

Post by **VW337** » Fri Jun 22, 2007 1:31 pm

Bfowler wrote:The akit one is the onlt nice kit in the current pg line. I go through LOTS of their kits.

For 8 and 4 gauge i would direct you to knuknoceptz, but pg's 1/0 kit is quite good. The battery terminal makes it well worth your while.

GO back to work.........oh wait that would be silly.

Post by **Bfowler** » Fri Jun 22, 2007 4:09 pm

i can multi task. drinking vodka tonics on a yacht IS work. ass

Post by **smgreen20** » Fri Jun 22, 2007 4:51 pm

Have a bigger intercooler do you? That friend of mine just bought $5Gs worth of upgrades for his Sy and when he got the battery relocation kit, it was missing a few parts.

dgoodhue · Post by **dgoodhue** » Sat Jun 23, 2007 3:30 am

I have a McCoy Motorsports A2A IC that goes in the stock location under bumper location of the water heater exchanger. Its a little bigger than RPM, but I think its now discontinued. If he has a stock or stock style turbo, the stock W2A works fine with a good pump & Alky (or water) injection.

I made my own battery relocation kit that sits under the bed. Make sure if you go through anysheet metal to use a good grommet. Almost every fire damage SyTy I have seen has been because of a battery relocation gone bad.

Post by **smgreen20** » Sun Jun 24, 2007 11:47 am

I'll pass that along, thanks.