Replacing the Exile 600.4

NappyFro · Post by **NappyFro** » Wed Jan 09, 2013 6:51 pm

So, I'm on the market for a replacement amp for my exile 600.4, and I'm leaning towards the r300.4. how does this amp stack up against the exile? I currently have the ti6cs installed in the doors. I plan to run the tweets off the fronts, and the mids off the rear of the amp. i would love to upgrade to the elite4 and elite 6.5s, but my wallet says no.

I have a JVC kd-a95bt headunit, and i run stinger 8000 series rca's , an elite 12 running off of an exile 1200.1...in case your wondering

Post by **AVICJR** » Wed Jan 09, 2013 6:53 pm

Killer system you currently have.....how do you like the Elite on the Exile amp?

NappyFro · Post by **NappyFro** » Wed Jan 09, 2013 7:09 pm

Sorry i ment to say the S400.4 not the r300.4. I would really like to get these ti's off of deck power, and back onto an amp

The elite off the exile....ummmm not enough power. It sound great, but you can tell i dont have enough power. Ive been pondering taking it out and adding 4 r3 10s and saving the elite12 for when i can fully have a whole elite system...and yea im talking about two elite 12s off of one elite1

Post by **AVICJR** » Wed Jan 09, 2013 7:20 pm

Or check eBay and grab another Exile X1200.1, one for each coil.

NappyFro · Post by **NappyFro** » Wed Jan 09, 2013 7:28 pm

AVICJR wrote:Or check eBay and grab another Exile X1200.1, one for each coil.

eh why bother, thats just cutting into my elite1 funds

Post by **AVICJR** » Wed Jan 09, 2013 7:41 pm

NappyFro wrote:eh why bother, thats just cutting into my elite1 funds

AWESOME!!

Drock · Post by **Drock** » Wed Jan 09, 2013 8:12 pm

Lets see some pics.

NappyFro · Post by **NappyFro** » Wed Jan 09, 2013 10:35 pm

Drock wrote:Lets see some pics.

Of what? My half primered beat up lowered frontier, or my install? Ill post pics of both, im currently going through a stereo crisis, and redoing everything. Once i decide on exactly what im installing and have everything mounted i will.

As of now its just an elite12 in a pre fab box, with the amp just laying on the floor. It looks like a flea market install.

As of right now im planning to install four r3 10d2 off the exile, with the basscube, and a remote volume knob for the bass. A s400.4 for the ti comps, and two remote volume knobs, one for the tweets and one for the mids, and ill have another remote volume knob for furture useage

Another setup would be the elite12 off the exile, the ti comps off the s400.4 a pair of r3 10s off another s400.4 for some serious midbass, pair of channels would have a remote volume knob, but the exile doesnt have enough balls for the 12.

My dream setup is elite compa off of a elite4(maybe 2 sets), ti/r3 10s off an elite2, and a pair of elite12s off of a elite1, with the volume knobs, the basscube, an audison bit1, and maybe a few line drivers if needed

If your wondering why i need volume knobs, is cause i listen to pretty muh everything, and i do mean everything, so i would like to beable to +/- tweets/mids/bass on the fly. I deliver pizza's for a living, so im in my truck atleast 30-35 hrs a week, so music is kinda part of my job too

Drock · Post by **Drock** » Wed Jan 09, 2013 11:38 pm

I was thinking of picks of the elite 12, I haven't seen many pics of installs will any of the new pg gear yet. I have a few of the elite amps. I just haven't had the time or a place to install one yet. One more week till the floor in the shop has cured enough to drive on. Ill put up lots of pics when I start. But I would love to see more elite installs.
Good luck with yours, it sounds like it will be awsome.

NappyFro · Post by **NappyFro** » Wed Jan 16, 2013 4:57 pm

Ok so i decided to pick up a ti800.4 to replace the exile. Now im just waiting for it to come in on friday. Im also debating weather to replace the ti6's with a set of elite6.5's...now its just a matter of time when i can install all of this stuff

Post by **Eric D** » Thu Jan 17, 2013 3:59 am

NappyFro wrote:Ok so i decided to pick up a ti800.4 to replace the exile. Now im just waiting for it to come in on friday. Im also debating weather to replace the ti6's with a set of elite6.5's...now its just a matter of time when i can install all of this stuff

Good choice. I use a Ti800.4 as a replacement for my Exile X800.4, and I prefer the Ti significantly.

NappyFro · Post by **NappyFro** » Thu Jan 17, 2013 12:52 pm

Eric D wrote:
Good choice. I use a Ti800.4 as a replacement for my Exile X800.4, and I prefer the Ti significantly.

Thats good to hear.

Post by **ttocs** » Fri Jan 18, 2013 7:54 pm

no doubt!

Audiophiliac · Post by **Audiophiliac** » Fri Jan 18, 2013 8:31 pm

Eric D wrote:
NappyFro wrote:Ok so i decided to pick up a ti800.4 to replace the exile. Now im just waiting for it to come in on friday. Im also debating weather to replace the ti6's with a set of elite6.5's...now its just a matter of time when i can install all of this stuff
Good choice. I use a Ti800.4 as a replacement for my Exile X800.4, and I prefer the Ti significantly.

That is some serious props for the Ti as I have used the Exile 800.4 and it is an awesome amplifier for sure!