zx250 power connector

[bunch62]

Can the power/remote connector for the zx250 be changed to the type fitted on the other zx range thanks Allan

[trickyricky]

Can the power/remote connector for the zx250 be changed to the type fitted on the other zx range thanks Allan

Is the original damaged? It can be swapped out but some mods will be required to the panel as the others use a bigger block.

[bunch62]

It's not damaged but the amp requires servicing and trying to fit the 4 awg that the car is wired with without correct crimpers is a problem, and I wanted all amps wiring to match if possible

[trickyricky]

Contact altser, he has the terminal blocks that your looking for. I think he sells them for 20.00 each, ask him though. Like I mention you might have to dremel the side panel to fit the bigger block. Its possible.

[bunch62]

[quote=thanks trickyricky "trickyricky"]Contact altser, he has the terminal blocks that your looking for. I think he sells them for 20.00 each, ask him though. Like I mention you might have to dremel the side panel to fit the bigger block. Its possible.[/quote]

[trickyricky]

Just checked my 500.4 and i don't think it's possible to switch the power terminal. Double check.

[bunch62]

Just compared the 250 with a 450, 250 is soldered 450 bolted plus main board totally different layout. May be possible but would require major mods, better to buy good crimper. But thanks trickyricky for the replies

[trickyricky]

Glad you saw it before buying blocks, your welcome.