I have the yellow cube and the knob that I put in your post. looks good with charcoal interior.vwdude wrote:Haha that was my post. The yellow ones are really rare. Agreed, talk to tricky Ricky. I recently sold mine.
Hey Rick... could you make me a few LPL44 knobs too? I could use a couple for the M100/M44... I know I can buy them new on Ebay, but I'd rather give you the business! Hmm.. maybe even a spare or two for the future. I've noticed some of the new ones are hardwired, and some have the RJ45 plug. Obviously, I'd prefer the RJ version.trickyricky wrote:I do not make the metal mounting case, only the pcb with the components along with the cable. Shouldn't be hard to reproduce except am not in the metal business otherwise I would provide them at a bit higher cost. I did provide a 1" x 1.5" aluminium angle I had found in the garage but ran out of it a while back and can't find any of it anywhere, looked pretty nice too it had that industrial look but the small pcb was exposed no biggy if its underneath steering wheel or flush mounted on vehicle panel.
I've been so busy at work that I have not been able to make any more remotes at the moment. I do have everything ready to go (FR4 boards, toner/etch solution, components needed, free software) just have to find time which is hard to do at the moment. Trust me I'll make some before the year is over, hopefully before this month is over.
trickyricky wrote:Sure thing, I think I was asking 20 or 25 for the LPL's can't remember. The last boards I recently etched came out wrong (circuit is wrong and I rather just toss those in the trash and start from scratch and do them right). Give me another week or two and hopefully I get them done before the year is over, the ole' 7-5 job has been keeping me very occupied and tired lol.
