I have the following equipment:
ZPA 0.3 amplifier
XVR4 Crossover
Ti Elite 6 Set
Ti Elite 12 Sub
I would like to go a little Old School and use the ZPA with the XVR4 to run my entire system passivley... The components will be in the kick panels and the sub will be under the dash of my '04 F150. So all the music will be from the front of the truck....
Any suggestions and or opinions would be GREATLY appreciated !
Thanks,
J
Single Amplifier System Design... You opinions / Suggestions
-
- Posts: 26
- Joined: Tue Feb 13, 2007 2:56 pm
-
- Posts: 26
- Joined: Tue Feb 13, 2007 2:56 pm
Depends on your tastes. On those power levels though, I think you would be better off with something like an RSD 10/12.
The Elite is a hungry woofer... it sounds best on at least 1200 watts. Your ZPA will offer about 500, but the passive crossover will also sap away some of that. Speaking of which, I am not sure about the specs of that crossover either... it may require a 4 ohm woofer to work, and the Elite would be 2 ohms.
The Elite is a hungry woofer... it sounds best on at least 1200 watts. Your ZPA will offer about 500, but the passive crossover will also sap away some of that. Speaking of which, I am not sure about the specs of that crossover either... it may require a 4 ohm woofer to work, and the Elite would be 2 ohms.
-
- Posts: 26
- Joined: Tue Feb 13, 2007 2:56 pm
Maybe this will help you.
http://cgi.ebay.com/New-Phoenix-Gold-XV ... dZViewItem
I concur with Stipud on the Ti Elite sub, you will need much more power to optimally run that beast. Also, it may be to cumbersome for an under-dash installation.
http://cgi.ebay.com/New-Phoenix-Gold-XV ... dZViewItem
I concur with Stipud on the Ti Elite sub, you will need much more power to optimally run that beast. Also, it may be to cumbersome for an under-dash installation.