Firewall

Post by **bdubs767** » Wed Sep 12, 2007 12:00 pm

What do you guys use to get through the firewall to run power wire?

ezamps · Post by **ezamps** » Wed Sep 12, 2007 12:32 pm

bdubs767 wrote:What do you guys use to get through the firewall to run power wire?

Unibit and an old one-piece antenna.

ydnap · Post by **ydnap** » Wed Sep 12, 2007 4:48 pm

horse whip and duct tape

Post by **AVICJR** » Wed Sep 12, 2007 4:55 pm

I found an existing hole. It was a big 2-3" hole with a rubber grommet feeding an electrical line to the cabin. I cut a tiny hole, and put a little dish soap and pulled it through taping a small piece of hangar wire on the end to keep it straight.

ydnap · Post by **ydnap** » Wed Sep 12, 2007 5:02 pm

Problem I had with my Tiburon is there are no, repeat no, places in the firewall you can run amp cable. Under inspection I realised that the entire fucking loom runs through the driver side fender

They stopped this after the RD tiburon because if you get fender bendered there and the loom gets severed badly enough the car will be considered a total

Was a right horrible bastard to get the 4awg through and into the footwell.

brenzbmr@sb · Post by **brenzbmr@sb** » Wed Sep 12, 2007 9:06 pm

what car?

second is use a existing grommet that has all the wires in it,

third a unibit and a good location on the firewall works for me

use a gromment and silicone the opening and you should be fine

depends on the car though

Firewall

Firewall

Re: Firewall