spl install

Post by **bdubs767** » Thu Nov 15, 2007 1:06 pm

For a friend's install he wants it loud and thats it. So Im desinging him a ported box with two RSd12ds off a x1200.1, but Im wondering if I should fire the box into the cabin and seal the subs off from the trunk or should I fire the subs backwards towards the end of the trunk.

What have you guys found to work better?

RATIFIED · Post by **RATIFIED** » Thu Nov 15, 2007 1:10 pm

From past experiences, I've found firing them into the trunk does better. Gives it a small cabin gain effect.

Post by **Bfowler** » Thu Nov 15, 2007 4:22 pm

If he can fold his seats down.....seal them in to the cabin firing forward.

you could slot load them into a vent in the rear deck.......

brenzbmr@sb · Post by **brenzbmr@sb** » Thu Nov 15, 2007 9:50 pm

if your looking for overall pressure then sealing the trunk from front of baffle or

what they call walling off your trunk is the best solution

Mackenzie · Post by **Mackenzie** » Fri Nov 16, 2007 9:20 am

I would personally do subs back, aero ports to the side.. If he doenst want to do aeros, I would probably just fire both the subs and port to the rear of the car, with tons of port area..