tld/basscube question

fordtough1 · Post by **fordtough1** » Tue Dec 11, 2007 8:19 pm

Does it matter which order I put these in? I was going to run from the headunit to the basscube to the linedriver. Would it be better to go headunit to linedriver to basscube? Or does it not really matter at all.

Just curious.

rolandk · Post by **rolandk** » Wed Dec 12, 2007 8:32 am

In your case it won't matter. If you had an external crossover then it would be best after the crossover, so the higher range of boosted freqs don't bleed into the mids.

Post by **Bfowler** » Wed Dec 12, 2007 8:48 am

it seems like a waste of line driver to use it after the bass cube. but it will work either way

fordtough1 · Post by **fordtough1** » Wed Dec 12, 2007 9:21 am

My concern was that I will be using a headunit with 5 volt outs, and I heard that the linedriver could drive that to 10, but the basscube says maximum 8 volt in. I didn't know if it would hurt the basscube to have the higher input voltage.

Post by **Bfowler** » Wed Dec 12, 2007 9:30 am

I didnt think about the bass cube only taking 8...

the line driver CAN put out 10volts there are pots on the inside that you could turn down to 8. I forgot what amps are you using?

fordtough1 · Post by **fordtough1** » Wed Dec 12, 2007 10:14 am

I'll be using an x200.2 for the fronts and an x1200.1 for subs

Post by **Bfowler** » Wed Dec 12, 2007 10:22 am

ah....in that case....get those 10 volts...use the bass cube first.

i should learn not to question Roland's advice

fordtough1 · Post by **fordtough1** » Wed Dec 12, 2007 10:26 am

That's what I thought, but I wanted to make sure.