Linedriver Question

dwnrodeo · Post by **dwnrodeo** » Wed Jun 11, 2008 11:09 am

This may be a dumb question but I plan on powering a RSDC 124 off of my X600.1. I am getting ready to set the line driver voltage and I see that you increase the voltage per channel until the speaker begins to distort then back it down a bit.
My question is, how do you set each channel independantly if there is only one speaker? Do you use a DMM to set the gains the same? Would increasing one channel at a time damage the woofer? Help please.

Post by **Bfowler** » Wed Jun 11, 2008 12:54 pm

iirc you measure the voltage at the line driver, then the sens on the amp (if nessicary)

the xenon's can take about 13 volts comfertably, so i would see how much voltage you can crank out of your line driver without clipping first and see if you even need to adjust the amp's gain (mine is at 0 with 10 volts from the tld66)

Post by **Francious70** » Wed Jun 11, 2008 2:36 pm

If you want to make sure they're set the same, yes, use a DMM. But you should be able to set it by eye, having the gains a small bit different won't damage anything.

dwnrodeo · Post by **dwnrodeo** » Thu Jun 12, 2008 3:49 am

Cool, thanks.