Right guys - Subwoofer amp suggestion!!!

PassatBloke · Post by **PassatBloke** » Tue Jul 08, 2008 6:32 am

I will be running (eventually) 2 x IDMAX 12" Subs Infinite baffle on my rear shelf, I would preferably like to have all phoenix gold gear but cant really find (i.e Im not as au fait as you guys with PG stuff) Something that will do 500-800w RMS x 2 for the Max's - Would prefer it to be older skool of course, so no Ti amps or anything

Any suggestions?

Post by **fuzzysnuggleduck** » Tue Jul 08, 2008 7:06 am

What impedance are you going to wire the subs into?

How about a ZPA 0.5? MS2250?

PassatBloke · Post by **PassatBloke** » Tue Jul 08, 2008 8:21 am

I can get dual 2's or dual 4's so pretty much any resistance!

Post by **Bfowler** » Tue Jul 08, 2008 8:24 am

you already have m44's...so maybe a m100 @ 2ohms with cooling fans?

PassatBloke · Post by **PassatBloke** » Tue Jul 08, 2008 8:31 am

I'll be getting an M100 off Marko for my Ti9 elites, I wouldnt have thought an M100 would have been powerfull enough to run 2 idmax's? - ZPA0.5 is favourate at the minute!

Post by **Bfowler** » Tue Jul 08, 2008 8:43 am

i would bet its running about 600watts @ 2ohms.... i just suggested it as it matched your other amps. you COULD go with a m100 EACH if you have some room to spare and extra $$$ burning a hole in your pocket

although a zpa0.5 would best a single one for sure.

Post by **stipud** » Tue Jul 08, 2008 8:45 am

PassatBloke wrote:I wouldnt have thought an M100 would have been powerfull enough to run 2 idmax's?

Get two then

PassatBloke · Post by **PassatBloke** » Tue Jul 08, 2008 8:50 am

Dont know if i could fit 3 x M100's and an M44 in the car

Post by **fuzzysnuggleduck** » Tue Jul 08, 2008 9:59 am

I have a single M100 running two RSD12D2 in 2ohm stereo and it gets plenty loud... but it sounds like you're really going for more than what a single M100 can provide.

Post by **stipud** » Tue Jul 08, 2008 10:16 am

PassatBloke wrote:Dont know if i could fit 3 x M100's and an M44 in the car

Run one sub then, geez

soth · Post by **soth** » Tue Jul 08, 2008 10:24 am

MS2250 or ZPA 0.5

flogger11 · Post by **flogger11** » Wed Jul 09, 2008 8:15 am

ZPA0.5, yummy...