
how much power u got on ur front stage??
as of today....none, because i ripped the whole lot out to sell my car 

Ti1 headunit (unique)
Outlaw in crate.
2x original shrouded ms2250's.
Route 66 in box + custom m100 to match.
Roadster 66 in flight case
Octane LE in box.
Reactor #186 in flight case.
Reactor EQ232
Ti400.2 AL
AX204A + EQ232 + ZPX2 + TBA set
ZCS6 component set
Tantrum+Titanium bass cubes
Ti12d Elite sub
DD5 + DD10 + 6 Ti blocks!
Outlaw in crate.
2x original shrouded ms2250's.
Route 66 in box + custom m100 to match.
Roadster 66 in flight case
Octane LE in box.
Reactor #186 in flight case.
Reactor EQ232
Ti400.2 AL
AX204A + EQ232 + ZPX2 + TBA set
ZCS6 component set
Tantrum+Titanium bass cubes
Ti12d Elite sub
DD5 + DD10 + 6 Ti blocks!
That would be passive with a HPF.mhyde71 wrote:well that's kinda a loaded question or one that is difficult to answer.. as I am really not sure to be honest.. I think they are active/passive if it can be??? I have the HU X'ed at 80 or 125 for the HPF (high pass filter).. but also use the passive xovers (that came with the ID Gear)... so does that make me passsive or active, or is that "passactive" - i dunnno I kinda covered this question in a recent past thread but didnt get a clear answer I dont think.. or i forgot to go back and look...gridracer wrote:Just curious why you wouldn't run the fronts active it would sound better.mhyde71 wrote: passive up front, active for subs (sub outs crossed at 50/80/125 depending and fronts crossed at 80 or 125 ) actu![]()
![]()
BUT ALWAYS LOOKING FOR WAYS TO IMPROVE - Help A Brutha out - look out for'a Brutha!
I'm also running the ID Chameleons, only fully active - 200w to the midbasses, and 100w to the tweeter per side (the tweeter isn't actually taking all 100w, but anyway...). I'm still tweaking the x-over points, but they're roughly around 3.5kHz with a small gap.
I'm considering getting some 4" mids and running them passive with the stock ID crossovers and tweets with the 100w channels of my amp, and turning down the LPF on the midbasses to somwhere around 500Hz. It's just a matter of finding the right driver to match with the other components. Perhaps I'll have to get a different passive x-over.
[url=http://www.mobilesoundscience.com/f14/skywalker-trill-hunnit-213/]Skywalker Trill Hunnit[/url]
time for a new motor, there will be a new install including LE amps so something to look forward to
i just hope it'll sound as good as the last one

i just hope it'll sound as good as the last one

Ti1 headunit (unique)
Outlaw in crate.
2x original shrouded ms2250's.
Route 66 in box + custom m100 to match.
Roadster 66 in flight case
Octane LE in box.
Reactor #186 in flight case.
Reactor EQ232
Ti400.2 AL
AX204A + EQ232 + ZPX2 + TBA set
ZCS6 component set
Tantrum+Titanium bass cubes
Ti12d Elite sub
DD5 + DD10 + 6 Ti blocks!
Outlaw in crate.
2x original shrouded ms2250's.
Route 66 in box + custom m100 to match.
Roadster 66 in flight case
Octane LE in box.
Reactor #186 in flight case.
Reactor EQ232
Ti400.2 AL
AX204A + EQ232 + ZPX2 + TBA set
ZCS6 component set
Tantrum+Titanium bass cubes
Ti12d Elite sub
DD5 + DD10 + 6 Ti blocks!
ha ha! i took that out with care and gave the face plate a clean too then wrapped it up for short term storage!Bfowler wrote:^so....got any headunits you want to sell
Ti1 headunit (unique)
Outlaw in crate.
2x original shrouded ms2250's.
Route 66 in box + custom m100 to match.
Roadster 66 in flight case
Octane LE in box.
Reactor #186 in flight case.
Reactor EQ232
Ti400.2 AL
AX204A + EQ232 + ZPX2 + TBA set
ZCS6 component set
Tantrum+Titanium bass cubes
Ti12d Elite sub
DD5 + DD10 + 6 Ti blocks!
Outlaw in crate.
2x original shrouded ms2250's.
Route 66 in box + custom m100 to match.
Roadster 66 in flight case
Octane LE in box.
Reactor #186 in flight case.
Reactor EQ232
Ti400.2 AL
AX204A + EQ232 + ZPX2 + TBA set
ZCS6 component set
Tantrum+Titanium bass cubes
Ti12d Elite sub
DD5 + DD10 + 6 Ti blocks!