Need amp recommendation for RSd65cs

nelobynature · Post by **nelobynature** » Fri Dec 05, 2008 12:54 pm

I'm going to purchase front RSd65cs components for my subaru, and was stumped on which amp would be optimal for these speakers.

I was looking at the possibility of getting this one and bridging it, but wasn't sure if this would be the best setup. Any recommendations? Would this be a good choice?

Phoenix Gold RSd300.4
[/img]http://www.onlinecarstereo.com/UIContro ... d3a842f5fe[/img]
50Wx4 4-Channel Car Amplifier
# RMS Power Range : 48-300 Watts
# Number Of Channels: 4
# Low Frequency response: 20 Hz
# High Frequency Response: 20000 Hz[/url]

Post by **Rold Gold** » Fri Dec 05, 2008 1:17 pm

Are ya planning to replace/power the rear also? I'd say a Zenon 100.4 would do the job. But a 200.4 would really do it too.

nelobynature · Post by **nelobynature** » Fri Dec 05, 2008 1:34 pm

no for now i'm just doing the fronts and might just fade out the rears.

Post by **fuzzysnuggleduck** » Fri Dec 05, 2008 1:45 pm

The RSd300.4 bridged would be just fine. Very similar to my M44 bridged, which is great.

There are lots of amps that could do the job well, but if you want a new amp right now at a low cost with high performance, the RSd300.4 is great. Want a little more power or options for the future? Go with the RSd500.4

Post by **Rold Gold** » Fri Dec 05, 2008 2:13 pm

^^^^^^^YEP............

Post by **Bfowler** » Fri Dec 05, 2008 3:08 pm

how loud do you like it? anything from 50 watts to 200 honestly. i have even ran them on deck power and they sounded decent. they are verital and awesome