Question about distribution block
Question about distribution block
I have two 4 gauge wires coming to my battery and I figured the best way to connect them to the battery is through a distribution block. I was thinking about just going to bestbuy today and pick one up. I would also need a 1/O gauge wire to connect that from the block to the battery. Where do I put the fuse for all of this? I currently have two fuses on both of these wires but they are not hooked up. I looked at a diagram and it says that I only need one between the battery and the block. So should i take the ones i currently have off and just have that one? Also, What size fuse should I use if i need one between the battery and the block? Thanks
Personally, I'd grab a set of PG 0/1g(4g reducer included) batt terminals. The new line is pretty sweet I have to say. Check these out-
http://rodinaudio.com/pgMobile/pdf/accessories.pdf
http://rodinaudio.com/pgMobile/pdf/accessories.pdf
Those tender little burgers with them little, itty-bitty grilled onions that just explode in ya mouth like flavor crystals every time you bite into one.. just makes me want to burn this muthafuka down.... Come on, Pookie, let's burn this muthafuka down!!!
