looking for info on a tx406

stockgp · Post by **stockgp** » Sat Jan 31, 2009 10:11 am

anyone?

i've had this thing sitting around for i don't know how long. it came with a printed manual from an ax406a, and that's all i know.

i'd like to use it if i can, especially if i can overlap crossover points. but first, i need to know where to get the crossover modules. are these the kind you can build yourself with resistors?

any and all help will be greatly appreciated.

thanks

Post by **fuzzysnuggleduck** » Sat Jan 31, 2009 11:09 am

I have no idea what a TX406 is but there definitely is a AX406A.

Manual is available on our repository:

http://download.phoenixphorum.com/Manua ... AX406A.pdf

And yes, this thing uses RNET (resistor networks). You can find info about them in the manual or in our HOWTO thread here:

http://phoenixphorum.com/ordering-rnets-vt1731.html

Basically, the value of resistors you use will determine the xover points.

Post by **stipud** » Sat Jan 31, 2009 1:15 pm

TX is just the Tantrum version AX406 IIRC

stockgp · Post by **stockgp** » Sat Jan 31, 2009 2:15 pm

the little manual has a sticker on it that says " the item you have purchased is newer than is pictured, but the specificattions are the same." or something to that effect.

so since it is the same as the ax406, can you overlap crossover points? i have yet to really look at it. it's new in box and i wanted to keep it that way until i was ready to use it.

Post by **AVICJR** » Sun Feb 01, 2009 6:01 am

stockgp wrote:so since it is the same as the ax406, can you overlap crossover points?

Yes. You'll have to change out the RNETS like Fuzzy said above to get the desired frequencies.

stockgp · Post by **stockgp** » Wed Feb 11, 2009 6:19 pm

a couple pics for you guys.

thanks for the info.