zx500v2 caps, speaker connector markings

[bunch62]

have just checked the caps but find they are of the panasonic make,do they need still need changing. while looking inside i noticed the speaker connections are marked different on the circuit board and above connectors on outside have pictures but cant load at present

[bunch62]

have just found this ,http://www.soundbuggy.com/Eric/Car%20Au ... index.html, thats the first question answered any thoughts on the second, thanks in advance

[Eric D]

Use the information marked on the outside of the amplifier. The reason they are different on the inside is due to how the amp works. One channel is normal, and the other is internally made 180deg out of phase. They then run that channel to the speaker (-) instead of the (+). This is so you can bridge the amp.

[bunch62]

thanks Eric D for the reply, can you recomend someone to carry out the cap replacement

[Eric D]

If you know anything about a soldering iron you could probably do this yourself. Otherwise, there are a lot of people here who know what they are doing, and could probably help you out. I would have been willing to help you some time ago, but I just don't have time to work on amps anymore.

[tonym]

thanks Eric D for the reply, can you recomend someone to carry out the cap replacement

I was going to say ericd or valeks

this is valeks...
www.altser.com

this guy can help you...

hes done the repairs for PG for years till they moved out of portland.....


see the flat rate list on that site...that includes shipping back to you also...unless over seas... I would think

good luck

[bunch62]

thanks tonym will check later