Kick Panels
Ultimately the goal was to spred them out as far as possible. The kick area was cleared out and a baffle was glassed in the actual frame of the car.


Door Pods
The 9" Elite's are intended for a sealed enclosure. So sealed it is. Notice the use of water to determine the exact airspace required. As for finishing the doors, I'm undecided. Either the lower half will be done in carbon fiber and the center section in suede, or visa versa. Then some polished rings and other highlights should look classy yet subtle.



Sub Enclosures
This was the funnest part (not!). Utilizing the dead space in the side panels, I was able to keep the hatch clear of a large enclosure and left room for the amps which take up all the space in the floor. Also now I'm able to toy with running my subs in stereo!



Functional But not pretty


The amps are mounted in the floor of the hatch. Literally just screwed down to a piece of MDF for the time being. So there was nothing to show there. Yes I gave up my spare but with the vehicle lowered and custom rims, the little doughnut spare was useless anyway.
The system is fully funtional. Which is kinda bad cause now I'm dragging my feet to finish. But the finishing touches will include a bunch of aluminum and carbon fiber that will tie the exterior and engine bay all together.